Key Information
The Hanningfield Uni-Cap is a flexible silicone rubber seal which provides a cost-effective method for the dust-tight transfer or containment of powders.
Technical Description
Design & Operation
A dust-tight seal can be made with the penetrating spigot by cutting a hole in the centre of the cap. This enables the contained charging of mills, tablet presses, vessels, drums / IBCs and almost any other item of process equipment where charging / discharging can produce dust. After the charging process is complete, the cap (with hole) can be replaced with a cap (without hole) to seal off the inlet.
Uni-Cap Sizes
Available in 2.5″, 5″, 8″, 8″ (Tri-Clover profile), 10″, 12″ and 16″, the Uni-Cap is designed to be compatible with our range of stainless steel mounting rings. This allows the cap to be easily fitted or retrofitted to any process.
Standard Hole Sizes
While we can cut any size hole required, the standard hole sizes we offer are: 80mm, 125mm, 145mm, 175mm, 200mm and 210mm.
Construction & Customisation
As standard, the caps are manufactured from translucent silicone (FDA CFR 177.2600), although we can accommodate specific requirements for material (e.g. EPDM) or colour (e.g. blue) in dedicated batches to satisfy your application. We are also able to introduce new tooling for unlisted sizes upon request.
Specification
Typical Applications
Downloads
Choose a Model
Uni-Cap 2.5″ (60mm)
The cap is designed to fit onto the Uni-Cap 2.5″ Mounting Ring, enabling it to be fitted or retrofitted to any process.
Uni-Cap 5″ (127mm)
The cap is designed to fit onto the Uni-Cap 5″ Mounting Ring, enabling it to be fitted or retrofitted to any process.
Uni-Cap 8″ (200mm)
The cap is designed to fit onto the Uni-Cap 8″ Mounting Ring, enabling it to be fitted or retrofitted to any process.
Uni-Cap 10″ (250mm)
The cap is designed to fit onto the Uni-Cap 10″ Mounting Ring, enabling it to be fitted or retrofitted to any process.
Uni-Cap 12″ (315mm)
The cap is designed to fit onto the Uni-Cap 12″ Mounting Ring, enabling it to be fitted or retrofitted to any process.
Uni-Cap 16″ (400mm)
The cap is designed to fit onto the Uni-Cap 16″ Mounting Ring, enabling it to be fitted or retrofitted to any process.
